Hydroform Rubber Tray Pads
Mosites #651 Tray Pads were developed to serve as a protective bladder or diaphragm in hydraulic fluid presses. It is typically sold in roll sheet .5” to .625” thick by 48” wide by 120” to 160”. Available with wedge shaped inserts installed at one end to facilitate winding the sheet on a carriage drum. Its primary function is to protect the main bladder from the possibility of punctures from sharp tool edges.
Our Hydroform Rubber Tray Pad Products
Showing all 2 results
Custom thickness & widths available upon request. Minimum order may be required.
Physical Properties
The physical properties shown below were obtained on 0.080 inch thick molded ASTM samples. They are typical of Mosites #651-50 Y neoprene compound, but they should not be used to set Quality Control Specification minimum requirements.
| Typical Physical Properties | |||||
|---|---|---|---|---|---|
| Hardness (Shore A) | 61 | ||||
| Tensile Strength (psi) | 2358 | ||||
| Elongation at Break (%) | 744% | ||||
| Modulus at 100% Elongation (psi) | 357 | ||||
| Modulus at 300% Elongation (psi) | 839 | ||||
| Tear Strength (ppi) | 250 | ||||
| Specific Gravity | 1.50 | ||||
